CubCadet Ultima ZTS Serie Manuel De L'utilisateur page 10

ADJUSTING THE STEERING WHEEL
1. To tilt the steering wheel column (a) forward, lift the steering
column adjustment lever (b), place the steering wheel
column (a) in the desired position and then release the
steering wheel column adjustment lever (b) to secure the
steering wheel column in place (Figure 8).
Figure 8
NOTE: When the steering column adjustment lever is lifted, the
steering wheel column will begin to raise up. Apply downward
pressure on the steering wheel to lower the steering wheel
column, if needed.
Lower Discharge Chute Deflector
WARNING
Never operate the mower deck without the chute
deflector installed and in the down position.
ATTACHING THE CHUTE DEFLECTOR (IF NECESSARY)
1. Remove the keys attached with a zip tie to the chute bracket.
2. Remove the flange lock nut and hex screw from the deck.
3. Place the chute deflector on the deck, be sure to insert
the tabs on the chute deflector into the holes on the deck
(Figure 9).
5
3
5
4
Figure 9
4. Slide the chute deflector toward the rear of the tractor until
the bolt hole in the chute deflector aligns with the hole in the
deck (Figure 9).
a
b
4
SET-UP
5. Secure the chute deflector in place with the flange lock nut
and hex screw removed in Step 2. Tighten to 102-124 in-lbs
(12-14 N-m). Skip ahead to Setting Deck Wheels (if equipped).
REMOVING THE STOP BRACKET (IF NECESSARY)
1. If the chute is shipped attached and with a stop bracket
holding the chute upright, the stop brackets must be
removed prior to operating the tractor.
2. Holding the chute deflector fully upward, remove the stop
bracket. Lower the chute deflector and discard the stop
bracket (Figure 10).
Setting Deck Wheels (if equipped)
NOTE: The deck wheels are an anti-scalp feature of the deck and
are not designed to support the weight of the cutting deck.
1. Move the tractor to a level surface, preferably pavement.
2. Check tire pressure, adjust if necessary (see tire side wall for
proper tire pressure).
3. Make sure the deck is level side-to-side and properly pitched
(see the Product Care section for deck leveling information
and instructions).
4. Place deck lift lever or knob in the desired mowing height
position and lower deck.
5. Check the wheels for contact or excessive clearance with the
surface below.
NOTE: The deck wheels should have between 1⁄4 inch (6.35
mm) and 1⁄2 inch (12.7 mm) clearance above the ground.
6. Remove the lock nut (a), gauge wheel (b) and shoulder screw
(c) from the deck (Figure 11).
c
b
7. Insert the shoulder screw (c) into one of four index holes on
the deck wheel bracket. Allow a 1⁄4-1⁄2 inch (6.35-12.7 mm)
clearance between the ground and gauge wheel (Figure 11).
10
Figure 10
a
Figure 11