Publicité
Les langues disponibles
Les langues disponibles
Check Engine Mounting Bolt Torque
(Tighten to 325-450 in-lbs
(37-50 N-m))
Check Blade Mount Nut Torque
(Tighten to 70-90 ft-lbs
(95-122 N-m))
Check Spark Plug Condition & Gap
Engine Break-In Oil Change
Change Engine Oil
Check Fuel System
(Lines, Tank, Cap, Fittings)
Check Spark Arrestor
Replace Oil Filter
Clean or Change Air Filter
Replace Fuel Filter
Have Valve Lash Checked
& Adjusted*
* -- Have this item performed by an authorized service dealer
NOTE: This Operator's Manual covers several models. Tractor
features may vary by model. Not all features in this manual are
applicable to all tractor models and the tractor depicted may
differ from yours.
POST-OPERATION TRACTOR CARE
After each operation of the tractor, to ensure safe operating
conditions, refer to Maintenance Schedule chart in this manual
for proper tractor care.
WARNING
Failure to follow these recommendations may result
in serious injury to yourself or others and may cause
damage to the tractor.
CLEANING THE UNDERSIDE OF THE DECK
Deck Wash System (if equipped)
Your tractor's deck may be equipped with a water port on its
surface as part of its deck wash system.
Use the deck wash system to rinse grass clippings from the
deck's underside and prevent the buildup of corrosive chemicals.
Complete the following steps AFTER EACH MOWING:
1. Attach the nozzle adapter to a standard garden hose
connected to a water supply.
PRODUCT CARE
After
Every
Before
First 5
10
Each Use
Hours
Hours
P
P
P
P
P
22
Every
Every
Every
25
50
100
Hours
Hours
Hours
P
P
P
P
P
P
P
P
# -- Perform more often in dry conditions and/or when mulching
2. Move the tractor to an area within reach of the hose where
the dispersal of wet grass clippings is acceptable. Disengage
the PTO, engage the parking brake and stop the engine.
3. Pull back the lock collar (a) of the nozzle adapter (b) and push
the nozzle adapter onto the deck wash nozzle (c). Release the
lock collar to lock the nozzle adapter on the deck wash nozzle
(Figure 22).
b
a
c
Figure 22
4. Turn on the water supply.
5. From the tractor operator's seat, start the engine and engage
the PTO. Allow to run as needed. Disengage the PTO and stop
the engine.
6. Turn off the water supply.
7. Pull back the lock collar of the nozzle adapter to disconnect
the nozzle adapter from the deck wash nozzle.
Every
Prior to
200
Storing
Hours
Manual
P
P
P
P
P
P
P
P
See
Engine
P
P
P
P
P
P
P
P
P
P
Publicité
