2. Throttle Control (if equipped) - Push the throttle
control lever forward to increase the engine speed. The
tractor is designed to operate with the throttle control
lever at full throttle (FAST) when the tractor is being
driven and the tractor deck is engaged. Pull the throttle
control lever rearward to decrease the engine speed.
3. Electronic Governor Control (if equipped) - When
set in a given position, a uniform engine speed will be
maintained. To increase engine revolutions per minute
(RPM), turn knob clockwise.
MIL (if equipped) - The Multifunction Indicator Light
(MIL) provides diagnostic information for the engine. If
the MIL lights up and/or flashes see the service manual or
contact your service center.
Q. CHOKE CONTROL (IF EQUIPPED)
The choke control determines the
position of the engine choke. Pull the
knob out to choke the engine; push the
knob in to open the choke.
R. HEADLIGHTS
The headlights are located on the front of the frame. The
headlights are ON whenever the ignition key is rotated out of
the STOP position and OFF when the ignition key is moved to the
STOP position.
S. SEAT ADJUSTMENT LEVER
The seat adjustment lever is located under the seat. The seat
adjustment lever allows for adjustment forward or backward of
the operator's seat. Refer to the Set-Up section for instructions
on adjusting the seat position.
T. MULTI-TOOL
The multi-tool (a) is located on the front of the right console. The
multi-tool (a) can be used as a deck lift lockout, to remove the
footpan bolt, and can be used as a removal tool with the 1/2 inch
socket end. See the Product Care section for more information on
multi-tool (a) usage (Figure 18).
a
Figure 18
OPERATION
OPERATION
Before Operating Your Tractor
• Before operation, refer to the Maintenance Schedule chart
located in this manual for regularly scheduled service items.
• This engine is certified to operate only on clean, fresh,
unleaded gasoline. Fill only with clean, fresh, unleaded
gasoline with a pump sticker octane rating of 87 or higher.
• Do not use gasoline left over from the previous season, to
minimize gum deposits in the fuel system.
• Gasohol (up to 10% ethyl alcohol, 90% unleaded gasoline by
volume) is an approved fuel. Other gasoline/alcohol blends
are not approved.
• Methyl Tertiary Butyl Ether (MTBE) and unleaded gasoline
blends (up to a maximum of 15% MTBE by volume)
are approved fuels. Other gasoline/ether blends are
not approved.
Safety Interlock System
Do not operate the tractor if the safety interlock system
is malfunctioning. This system was designed for your
safety and protection.
This tractor is equipped with a safety interlock system for the
protection of the operator. If the interlock system should ever
malfunction, do not operate the tractor. Contact an authorized
service dealer.
• The safety interlock system prevents the engine from
cranking or starting unless the parking brake is engaged and
the PTO switch is in the DISENGAGED (OFF) position.
• The engine will automatically shut OFF if the operator leaves
the seat before engaging the parking brake.
• The engine will automatically shut OFF if the operator leaves
the tractor's seat with the PTO switch in the ENGAGED (ON)
position, regardless of whether the parking brake is engaged.
Checking the Safety Interlock Circuits
Periodically check the safety interlock circuits to ensure they are
working properly. If a safety circuit is not working as designed,
contact an authorized service dealer to have the tractor
inspected. Do NOT operate the tractor if any safety circuit is
not functioning properly. To check the safety circuits, proceed
as follows:
1. Pull the PTO upward to the ENGAGED (ON) position.
Momentarily turn the ignition switch to the START position;
the engine should not crank.
2. With the tractor running move both drive pedals to the
neutral position; then lift upward from the operator's seat.
The engine should stop.
17
WARNING