Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
COOKING
ANY ADJUSTMENT, MAINTENANCE, ETC. MUST BE CARRIED OUT
WITH THE HOB UNPLUGGED AT THE MAINS.
The glass-ceramic cooktop permits rapid vertical transmission of heat from the heating element below the
cooktop to the pots or pans placed on top of it. Heat does not spread horizontally, thus at a distance of just
a few centimetres from the cooking zone, the glass remains relatively "cool" to the touch.
Before cooking for the first time, it is necessary to clean the surface of the appliance. This should be done
using only recommended ceramic hob cleaners. After cleaning, the appliance should be operated in the
following manner to remove any residues or moisture that may be present within the appliance.
Before switching on, check the control signal to be sure that the desired cooking zone is selected.
It is best to place the pot or pan on the cooking zone before switching on, and remove it only after switching off.
Never cook food directly on the glass-ceramic cooktop; always use suitable pots or containers.
Do not stare at the halogen lamps on the cooktop.
Absolutely do not leave the electric plates working without any pots on it.
Such incorrect usage may cause overheating, damages to the appliance and fire hazzard.
To switch on the electric plate, turn the knob or set the touch-control to the desired power intensity.
Numbers 1 to 6-10 (depending which type of cooktop) indicate the progressive temperature levels.
Depending on the food to cook, adjust the heat intensity following the suggestions below:
Control settings
Knob control - range
1-6
1-8
1-10
0
0
0
1
1
1-2
2
2
2-3
3
3
3-4
4
4
5
5
6
5
6
7-8
7
9
6
8
10
At the end of your cooking, always switch off the hob
RESIDUAL HEAT INDICATOR
These appliances have an indicator light that inform the user that the temperature of the glass is at a
dangerous level in the event of contact with the cooking zone.
In models with knobs control, each heating elements has a corresponding residual heat indicator light,
in models with touch control any residual heat is indicated by an "H" by the corresponding seven-segment display.
Once a cooking zone has been turned off, the corresponding light will stay on for a period of time
necessary for the zone to cool down below the critical level.
Absolutely do not touch the cooking areas or leave flammable objects near it until the light is off.
Cooking operation suggestions
Touch
control
0
1 - 2
For melting processes (butter or chocolate)
2 - 3
For keeping foods hot and heating small amounts of liquids.
3 - 4
For heating larger amounts and beating custards and sauces.
5
Slow boiling, for soups, pasta and risotto, continuing steaming
6
processes, and cooking steaks and fried foods in general.
7
Browning meat, roasted potatoes, fried fish, bringing large
8
9
Quick frying, char-grilled steaks, ect.
Off
amounts of water to the boil.
Publicité
Table des Matières
