Revitive CIRCULATION BOOSTER 5573AQ Manuel De L'utilisateur page 9

Instructions for use
f
Set the time for Revitive. The default time is 30 minutes. You can set the timer for
up to 60 minutes.
70
3o
If you do not want to use the default time of 30 minutes, set the time for the
number of minutes you want. You can use the controls on the control panel or
0 0
on the remote control.
3o
Press the
Press the
g
Press the
70
You can use the buttons on the control panel or remote control. Ensure both feet
3o
are on the foot-pads when increasing the intensity.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
h
Ensure you familiarise yourself with the feeling of the Medic Program. Use on a low intensity for 30-60 minutes once
per day for a few days.
Set the intensity at a level where you can feel the stimulation in your feet which creates a calf muscle contraction.
0
It is normal to feel tingling or varying sensations in your feet and calf muscles.
3
Revitive does not vibrate.
i
After a few days of familiarisation, use a higher intensity that provides you with strong but comfortable calf
muscle contractions.
Most people experience a strong contraction at intensity level 40 or over.
The IsoRocker® enables Revitive to rock up and down once muscle contractions are nearing the desired level. The
rocking is caused by muscle contractions in the leg, and the resulting ankle movement allowed by the IsoRocker is
a good indicator that the intensity level is sufficient to provide the therapy. Increasing the intensity above this level
will enhance the therapy, but should not be allowed to become uncomfortable.
You can set the intensity between 1-99.
Please note that the intensity required may vary from day to day.
If you feel pain or discomfort:
• Remove one or both feet from the foot-pads to stop the stimulation
• Lower the intensity of the foot-pads using the
control, before replacing your feet on Revitive
16
7376_IFU01_19000014.indd 16-17 7376_IFU01_19000014.indd 16-17
(+) Time Control to increase the time.
(–) Time Control to decrease the time.
(+) Intensity Control one time to start stimulation.
(–) Intensity Control on the control panel, or remote
j
If you remove one or both feet from the foot-pads, Revitive will pause the stimulation for up to 10 minutes.
The display will blink on and off and you will hear a beep. The timer will stop until the session is resumed. Do
not touch the foot-pads with your hands or pick up device until paused is enabled
The stimulation can be resumed by placing both feet back on the foot-pads and then pressing the
the Intensity Control.
While Revitive is paused, the intensity level can be reduced by pressing the
Intensity cannot be increased while Revitive is paused.
After 10 minutes of being in the paused state, Revitive will switch itself off.
k
The Time Display will start to count down in minutes as Revitive cycles through its program.
l
When Revitive times out, the Time Display reads 00 and you will hear three beeps.
m
Revitive switches itself off automatically.
EN
(+) button on
(–) button on the Intensity Control.
17
08/02/2023 13:58 08/02/2023 13:58