Publicité
Les langues disponibles
Les langues disponibles
Instructions for use
d
Attach the ends of the Body Pads to the Electrode cord.
Press connectors until there is no gap between them.
Leaving a gap may cause discomfort or no stimulation.
e
Plug the other end of the Electrode cord into the socket on the side of Revitive.
Plugging in the Electrode cord will automatically turn the foot-pads off.
f
Remove the plastic liner from the Body Pads, by peeling it off carefully. Replace the
Body Pads onto the plastic liner after use.
g
Press the Body Pads on the area you wish to apply electrical stimulation to, as shown
on page 19, gently pressing the adhesive side against the skin.
h
Press the power button on the device or on the remote control to turn Revitive
on.
0
0
3o
You will hear a beep and the display lights will light up. The
minutes, the
20
7376_IFU01_19000014.indd 20-21
7376_IFU01_19000014.indd 20-21
time will read 30
Intensity will read 00 and the
EMS symbol will be displayed.
Revitive Body Pads will automatically provide stimulation in
0 0
If you wish to use Revitive Body Pads in TENS Mode press the
on the remote control.
3o
You will then see the
TENS symbol on the display.
See page 23 for further instructions on how to switch between EMS and TENS mode.
i
Set the time for Revitive. The default time is 30 minutes. You can set the timer
for up to 60 minutes
0
0
If you do not want to use the default time of 30 minutes, set the time for the
3o
number of minutes you want. You can use the controls on the control panel or
on the remote control.
Press the
(+) Time Control to increase the time.
Press the
(–) Time Control to decrease the time.
j
Press the
(+) Intensity Control once to start stimulation.
70
Continue to increase the intensity until you can feel the stimulation. You can set
3o
the intensity between 1-99.
You can use the buttons on the device or remote control.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
It is normal to feel tingling or varying sensations in the muscles you are treating.
Please note that the intensity required may vary from day to day.
If you feel pain or discomfort:
•
Lower the intensity of the Body Pads using the
control.
•
You can also choose to stop therapy before the end of the 30 minute session to avoid skin irritation
and/or muscle fatigue. You can do this by pressing the
remote control.
EN
EMS mode.
TENS button
(–) Intensity Control on the device or remote
power button on the device or on the
21
08/02/2023 13:58
08/02/2023 13:58
Publicité
