Publicité
Les langues disponibles
Les langues disponibles
Automatic cleaning using the
GB
PYROLYTIC cycle
During the PYROLYTIC cycle, the internal
temperature of the oven reaches 500°C. When the
pyrolytic cycle is activated, food and grime residues
are burnt away. Dirt is literally incinerated.
Keep children away from the appliance during the
automatic cleaning cycle as surfaces may become
very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause
for concern: this process is both normal and hazard-
free.
Before initiating the PYROLYTIC cycle:
• remove large or coarse food residues from the
inside of the oven using a damp sponge. Do not
use detergents;
• remove all accessories;
• do not place tea towels or pot holders over the
oven handle;
• turn the SELECTOR knob to the "0" position.
! If the oven is too hot, the pyrolytic cycle may not
start. Wait for the oven to cool down.
! The cycle may only be started once the oven door
has been closed.
To activate the PYROLITIC cleaning cycle, press
and hold the
button for approximately 4
seconds. The SET TIME KNOB may be used to
select the desired cleaning level; there are three
default time settings which cannot be modified.
1. Economy (ECO): turn the knob towards "-".
Duration 1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30
minutes.
3. Intensive (INT): turn the knob towards "+".
Duration 2 hours.
4. Press the
button to confirm.
An end time for the PYROLITIC cycle (as for a
normal cooking cycle) may be programmed (see
Programming the automatic cleaning end time).
26
All manuals and user guides at all-guides.com
Safety devices
• the
icon on the display, when lit, indicates
that the oven door was automatically locked as
soon as the temperature reached a high value;
• the
icon indicates that the cleaning cycle
may be cancelled at any time by pressing the
button;
• if a malfunction occurs, the heating elements will
be switched off;
• once the oven door has been locked, you cannot
change the duration and cycle end time settings.
Programming the automatic cleaning end time
1. Press the
button until the
numerical digits on the DISPLAY begin to flash.
2. Turn the SET TIME KNOB towards "+" and "-" to
adjust the hour value.
3. Press the
button again so that the other two
numerical digits on the DISPLAY begin to flash.
4. Turn the SET TIME KNOB towards "+" and "-" to
adjust the minute value.
5. Press the
button again to confirm.
6. When the set time has elapsed, the text END
appears on the display and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy
PYROLYTIC cycle has been selected: default set
duration 1 hour. 12:30 is scheduled as the end
time. The programme will start automatically at
11:30 a.m.
Programming has been completed when the
icons light up. The DISPLAY shows the
PYROLITIC cycle end time and duration alternately.
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the
oven has cooled down sufficiently before you can
open the oven door. You will notice some white dust
deposits on the bottom and the sides of your oven;
remove these deposits with a damp sponge once
the oven has cooled down completely. Alternatively,
you can make use of the already heated oven, in
which case it is not necessary to remove the
deposits, they are completely harmless and will not
affect your food in any way.
icon and the two
and
Publicité
