Evaluating Results - Beurer BM 77 Mode D'emploi

The cuff automatically inflates.
Measuring can be cancelled at any time by pressing
the Start/stop button
The cuff's air pressure is slowly released. If you already
recognise a tendency for high blood pressure, you should
reinflate the cuff and increase the cuff's pressure again. As
soon as a pulse is found, the pulse symbol
• Systolic pressure, diastolic pressure and
pulse measurements are displayed. The
resting indicator display (see chapter 6)
illuminates in accordance with the positive
or negative classification.
• appears if the measurement could
not be performed properly. Observe the
chapter on error messages/troubleshooting
in these instructions for use and repeat the
measurement.
• Now select the desired user memory by pressing the
M1 or M2 memory buttons. If you do not select a user
memory, the measurement is stored in the most re-
cently used user memory. The relevant symbol
appears on the display.
• Using the Start/stop button
pressure monitor. The measurement is then stored in
the selected user memory.
.
is displayed.
or
, switch off the blood
If Bluetooth data transfer has been activated, data is
®
transferred after having confirmed the user memory. The
blood pressure monitor shows the Bluetooth
during data transfer.
Please note that you must add the blood pres-
sure monitor in "My devices" in the " beurer
HealthManager" app to enable data transfers. The
" beurer HealthManager" app must be active to allow
data transfers.
If the current data is not displayed on your smart-
phone, repeat the transfer as described in Chapter 8.
If you forget to turn off the blood pressure monitor, it will
switch off automatically after approximately 3 minutes. In
this case too, the value is stored in the selected or most
recent user memory and the data is transferred if Blue­
tooth data transfer has been activated. The Bluetooth
®
symbol appears on the blood pressure monitor display
during data transfer.
• Wait at least 5 minutes before taking an-
other measurement!

6. Evaluating results

Cardiac arrhythmia:
This instrument can identify possible cardiac arrhythmia disor-
ders during measurement and if necessary indicates the meas-
urement with the flashing icon
This may be an indicator for arrhythmia. Arrhythmia is a condi-
tion where the heart rhythm is abnormal as a result of defects
30
symbol
®
®
.