Vasco BASIC Manuel D'utilisation Et D'installation page 82

2- If the room temperature difference is positive, example :
Setting temperature (what you want) = 19°C.
Ambient temperature (what you read on a reliable thermometer) = 21°C.
Difference measured = +2 °C.
To correct, then proceed as follows :
Sensor temperature = 21°C
Increase the temperature measured by the ambient
temperature sensor by 2°C by pressing
To validate the new value press
The reset to zero of the sensor calibration
1- When the temperature measured by the sensor appears,
press or for at least 3 seconds.
2- To save and move automatically to the next setting press
To exit the settings, press
RADIATOR POWER
To guarantee the correct functioning of the radiator and to be able to correctly estimate the energy consumption, it is
essential to adjust the power of the radiator.
BASIC: this setting must be made upon initial commissioning.
RF: when paired with the RF remote control, this setting is automatically discussed.
1- Select a value between 500W and 1500W by
pressing or .
2- To save and move automatically to the next setting
press .
To confirm and exit the settings, press 3x
RESTORING FACTORY SETTINGS
If the PIN code protection is disabled, the user, installer and advanced installer settings are re-initialized:
rESt
1-
appears on the display.
20
.
. To exit the settings, press
3 times.
.
3 times.
.
21 . 0 c
Pro
O
2 .
0
23 . 0 c
O
Pro
2 .
0
3 sec.
500
rEst