Vasco BASIC Manuel D'utilisation Et D'installation page 81

ADVANCED INSTALLER SETTINGS
ACCES
From Auto, Comfort, Eco or Frost protection mode:
Information display
Press for
1
5 seconds
Information display
Setting sequence:
Temperature sensor calibration
TEMPERATURE SENSOR CALIBRATION
Overview
Important: This operation is reserved for professional installers only; any wrong
changes would result in control anomalies.
The calibration adjusts the temperature measured by the ambient temperature sensor to
compensate for a deviation from + 5°C to - 5°C by intervals of 0.1°C.
The calibration can be performed for each linked control. Depending on the number of
controls, you start by setting the calibration from the first control, then for the second,
to the last control. You can identify the control number when you set the calibration on
the display.
Calibration
1- If the room temperature difference is negative, example :
Setting temperature (what you want) = 20°C.
Ambient temperature (what you read on a reliable thermometer) = 18°C.
Difference measured = -2°C.
Before carrying out the calibration it is recommended to wait for 4h after the setting temperature
modification to insure that the ambient temperature is stabilized.
To correct, then proceed as follows :
Sensor temperature = 24°C.
Decrease the temperature measured by the ambient
temperature sensor by 2°C by pressing
To validate the new value press
To exit the settings, press
Press briefly
twice
Long and simultaneous
10 seconds press
Radiator power
.
.
3 times.
Information display
1
Pro
= advanced
installer settings
Press briefly
Restoring factory settings
EN
Press for
10 seconds
24 . 0 c
O
24 . 0 c
O
Pro
-2 .
0
22 . 0 c c 22 . 0 c
O O
Pro
-2 . -2 . -2 . -2 . -2 . -2 .
0 0
19