Vasco BASIC Manuel D'utilisation Et D'installation page 72

SET A WEEK PROGRAM
1- From Auto, Comfort, Eco or Frost protection
mode, press for 5 seconds.
When the cursor moves over the time setting
symbol , briefly press
2- Press or to set the week program.
3- Select the desired program with
If desired, the standard times can be adjusted:
press for at least 5 seconds.
If the standard times apply: press
next day (go to step 4).
3.1- The start time flashes and with
you can change this time at 30 minute
intervals.
Press to save.
3.2- The end time flashes and with
you can change this time at 30 minute intervals.
Press to save.
4- The second day (Tuesday) flashes.
Repeat the procedure described above for
every day of the week.
5- Once you have selected a program for each day, confirm your selection by pressing
appear on the screen with the programs you have set for them. Press
return to "Auto mode". If no button is pressed for a few minutes, the controller automatically returns to "Auto Mode".
VIEW OF THE PROGRAMMED WEEK PROGRAM
From Auto, Comfort, Eco or Frost protection mode, press
each day of the week (Comfort, Eco, P1, P2 or P3) will scroll on display in front of you.
To exit the programme viewing mode, press
10
.
or .
to set the
or
or
twice.
1
2
1
5 sec.
1 2
1 2
2
1
twice to exit programming mode and
. for 5 seconds. Press
ConF ConF ConF
ConF ConF ConF
2
1
5 sec.
.
06 . 30 06 . 30 06 . 30
1
.
22 . 30 22 . 30 22 . 30
1 2
P1
. The days of the week
twice, the programme for
2