Vasco BASIC Manuel D'utilisation Et D'installation page 66

MOUNTING THE RF REMOTE CONTROL
On the wall
x2
Unscrew the 2 screws
under the RF remote control.
BINDING THE RF RECEIVER WITH THE RF REMOTE CONTROL
Is this sign already visible at the bottom right on the display, as in the following example?
The RF remote control and the RF receiver are not paired at the factory.
Attention: A maximum of 5 RF receivers can be connected to 1 RF remote control
Proceed as follows and do this for each RF receiver:
RF pairing:
1. Put the RF receiver in pairing mode by pressing the
The LED will start to blink in RED.
2. Put the RF remote control in frost protection mode by pressing
the button 3x and press
The RF remote control is in frost protection if
this symbol is visible on your screen:
3. To ensure correct operation of the radiator, the power of the radiator must be adjusted
via the RF remote control. This step is automatically covered during pairing.
The power is set to 500W as standard.
Use the and
Don´t know the output of your radiator? Contact your installer.
4. When the RF remote control and the RF receiver are linked, the
and is constantly displayed.
RF pairing cancellation:
Press more than 10 seconds on Memo button of the RF receiver.
04
Secure the wall plate with the
two screws provided using the
horizontal and vertical holes.
The radiator is already connected and you can skip this step.
for 5 sec.
keys to set the power (see rating plate radiator).
On the table stand
Insert the 2 pins
inside the wall plate.
button for 5 sec.
symbol appears
Slide the stand
to the right.
5 sec.
5 sec.
10 sec.