Parkside PDSA 20-Li C2 Instructions D'utilisation Et Consignes De Sécurité page 49

˜ 20 V battery pack ‒ charging
information
˜ Checking the battery pack
charging level
(Fig . H)
Check battery pack charge level: Press the
o
[ 29 ]
button . The charging level LEDs
light up:
LED
Red/yellow/green
Red/yellow
Red
˜ Charging the battery pack
(Fig . I)
NOTE
u
If the battery pack
battery to cool down completely before
charging .
u
The battery pack
any time without reducing the life .
u
Interrupting the charging process does not
damage the battery pack
u
Charge the battery pack
operation when it is at medium or low
charging level .
1 . The charging control LEDs (green
[ 32 ]
red ) indicate the status of the charger
and the battery pack
LED
Red LED lights up
Green LED lights up
Green and red LED
flashing
Red LED flashing
Green LED lights up
(without battery pack)
46 GB/IE
28 ] [
Charging level
Maximum
Medium
Low
21 ] [
is warm: Allow the
[ 21 ]
may be charged at
21 ] [
.
21 ] [
before
[ 33 ]
and
21 ] [
:
Status
Battery pack charges
Battery pack fully
charged
Battery pack
defective
Battery pack too cold
or too warm
Charger ready
2 . Insert the battery pack
[ 31 ]
charger .
3 . Connect the mains cord with mains plug
of the charger
4 . When the battery pack
charged: Remove the battery pack from
the charger
30 ] [
plug of the charger from the mains
socket .
˜ 12 V battery pack ‒ charging
information
(Fig . J)
˜ Charging the battery pack
m
WARNING!
u
Charge the battery pack
room only . Prior to inserting the battery
into the battery charger
outer surface of the battery pack is clean
and dry . There is a risk of injury due to
electric shock .
m
CAUTION!
u
Do not expose the battery pack
extreme conditions such as heat or impact .
Risk of injury from escaping electrolytic
solution! After eye/skin contact, rinse the
affected areas with water or a neutraliser
and consult a doctor .
31 ] [
NOTE
u
The battery pack
capacity once it has been charged several
times .
u
Charge the battery pack
it for the first time .
u
Only use chargers from the
X 12 V TEAM series to recharge the
battery pack
21 ] [
into the
31 ] [
to the mains socket .
21 ] [
is fully
[ 31 ]
. Then disconnect the mains
[ 34 ]
in a dry
36 ] [
, check that the
34 ] [
34 ] [
only reaches its full
34 ] [
before using
[ 34 ]
.
[ 30 ]
to