ProBreeze PB-10 Mode D'emploi page 6

CONNECTING THE WATER HOSE FOR CONTINUOUS DRAINING
For long-term use, it is recommended to connect a hose for continuous drainage. To
attach the hose:
Use a screwdriver or similar tool to remove the plastic
1.
covering from the continuous drainage hole at the
back of the dehumidifier.
2. Check that the water tank is securely in position.
Insert the hose into the water hose connector and
3.
check it is connected properly.
REMOVING AND EMPTYING THE WATER TANK
When the water tank is full three beeps will sound; the Water Tank Full Indicator Light
will continuously flash and the dehumidifier will pause operation to prevent the water
tank from overflowing. To remove and empty the water tank:
Turn off the dehumidifier, wait two minutes for the fan to stop, and unplug it from
1.
the wall socket.
Gently pull the water tank out from the front of the dehumidifier.
2.
Use handle to empty the water tank.
3.
4. Once empty, slot the tank back in carefully.
DO NOT remove the float from the top of the water tank as this may cause damage
and prevent the dehumidifier from functioning as intended.
5 | English
(12mm )