SCANGRIP CANVIK CENTER Instructions D'utilisation page 4

Operation Advice
•
Before placing the coil spring compressor onto the spring, lift the
vehicle until the wheel is completely free from the ground.
•
Place the spring compressor inside the spring and mount the lower jaw as
low as possible between two spring windings . Make sure to use the right
size of jaws.
Mare sure that the spring is clean were the jaws are mounted on
the windings. Wipe away crease and dirt
•
Place the higher jaw as high as possible in the spring windings to press as
many spring windings as possible.
•
Take care that the seating of the spring windings in the jaws is correct.
•
Hold on to the upper jaw until the spring compressor is firmly fixed.
•
Press the spring together by turning the spindle with an air wrench or a
ratchet spanner.
Use air wrench only with the supplied torque stick (Safety key)
which has a torque limit of max. 100 Nm.
•
Air wrench torque limit 180 Nm.
We recommend using an air ratchet instead.
•
Additional compression is not possible when the windings of
the spring are in contact with each other.
Do not continue to drive when the upper or lower travel ends are reached.
•
Spring and spring compressor is removed.
•
Release the coil spring compressor and remove it.