SCANGRIP CANVIK CENTER Instructions D'utilisation page 2

Working safely with this tool is possible only when the
operating and safety information are read completely
and the instructions contained therein are strictly fol-
lowed.
•
Before each use, check the unit for full functional capability. If the
functional capability is not ensured or if damage is detected, the
unit should not be used.
•
Do not make any construction changes to the unit.
•
Use only suitable jaws for the springs. Ensure that the spring is po-
sitioned correctly in the jaw. The centre line of the spring must be
centered in both jaws.
•
When compressing the spring, the spring windings should not come
in contact with each other.
•
Use air wrench only with the supplied torque stick (Safety key)
which has a torque limit of max. 100 Nm.
•
Air wrench torque limit 180 Nm.
We recommend using an air ratchet instead.
Operation Advice
The coil spring compressor is exclusively for compressing Wishbone and
Multilink System springs. Any other or further use is considered not as in-
tended.
For Your Safety