Parkside PSBM 750 B3 Traduction Des Instructions D'origine page 9

Use
WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Additional handle
NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached.
♦ Loosen the strap on the additional handle
by turning it clockwise.
♦ Push the additional handle
of the quick release chuck
♦ Turn the additional handle
position.
♦ The locking positions on the additional
handle must now be pushed over the
locking pin on the spindle of the appliance.
♦ Turn the additional handle
again to tighten it.
NOTE
► Move the additional handle
various locking positions depending on your
working position. Undo and lock the addi-
tional handle as described previously.
Depth stop (see fig. A)
♦ Undo the screw on the depth stop
♦ Insert the depth stop
handle .
♦ Make sure that the teeth on the depth stop
point upwards and downwards.
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
♦ Tighten the screw on the depth stop
lock the depth stop
│ GB │ IE
■ 6
in the direction
.
to the required
anticlockwise
into the
.
into the additional
out until the distance
to
into place.
Changing tools
♦ Turn the quick-release chuck
RELEASE to open it.
♦ Insert the desired tool into the quick-release
chuck .
♦ Turn the quick-release chuck
to tighten the tool.
GRIP
Operation
Select operating mode
Function selector switch
♦ Push the function selector switch
engages at the required symbol:
Function
Drilling
Impact drilling
Select direction of rotation
WARNING!
► The rotation direction switch
be used/adjusted if the appliance is at a
standstill.
♦ Select the direction of rotation by pressing the
rotation direction switch
right.
Preselecting the rotation speed
You can use the rotational speed preselector
adjusting wheel
speed. The speed you select depends on the
material to be processed. Work out the right
setting by carrying out a practice test.:
NOTE
► The appliance only reaches the set rotational
speed during continuous operation.
towards
towards
so that it
Symbol
may only
towards the left or
to preselect the rotational
PSBM 750 B3