Dometic NDS POWER & CONTROL TEMPRA TLB100 Instructions De Montage Et De Service page 10

EN
NOTICE! Damage hazard
To prevent damage to the equipment, deactivate all loads and the charger before battery installation.
NOTICE! Damage hazard
Battery cables must not be connected to the battery in reverse polarity, otherwise damage to the device
may occur.
NOTICE! Damage hazard
To prevent damage to the equipment always connect the positive cable first.
NOTICE! Damage hazard
Never connect multiple batteries in series.
NOTE The battery may only be installed in upright position on a horizontal surface.
Fig.  on page 3
1. Remove the terminal protection caps (1).
2.
NOTE Automotive terminal clamps may be connected with M8 screws and suitable washers.
Install the battery cables (2) to the corresponding terminal (3) using the bolts (4) included in the scope of deliv-
ery.
To ensure a secure electrical contact tighten the bolts to the end of the threads, but without using excessive
force.
3. Install the terminal protection caps (1).
4. If possible, secure the battery to the floor to avoid unexpected movements during the journey.
Installing and connecting the display (optional)
1. Follow the instructions given in the display manual.
Fig.  on page 3
2. Plug the display's connection cable into one of the N-BUS sockets (1).
NOTE Both N-BUS connectors can be used to connect the display or another N-BUS device.
Installing the smartphone application
To connect the battery with a Bluetooth® BLE compatible (v. 4.2 or higher) smartphone download the Domet-
ic Energy application:
10