HT SOLAR03 Manuel D'utilisation page 28

3. PREPARATION FOR USE
3.1. INITIAL CHECKS
Before shipping, the instrument has been checked from an electric
as well as a mechanical point of view. All possible precautions have
been taken so that the instrument is delivered undamaged.
However, we recommend generally checking the instrument in order
to detect possible damage suffered during transport. In case
anomalies are found, immediately contact the forwarding agent.
We also recommend checking that the packaging contains all
components indicated in § 7.3.1. In case of discrepancy, please
contact the Dealer. In case the instrument should be returned,
please follow the instructions given in § 8
3.2. DURING USE
Please carefully read
instructions:
•
Failure to comply with the caution notes and/or
instructions may damage the instrument and/or its
components or be a source of danger for the
operator.
•
The symbol " " indicates that the batteries are low.
Stop testing and replace or recharge the batteries
according to the indications given in § 6.1.
•
When the instrument is connected to the circuit being
tested, never touch any terminal, even if unused.
3.3. AFTER USE
When measurements are completed, turn off the instrument by
pressing and holding the ON/OFF key for a few seconds. If the
instrument is not to be used for a long time, remove the batteries.
3.4. POWER SUPPLY
The instrument is powered by 2x1.5V batteries type AA IEC LR06 or
2x1.2V NiMH type AA rechargeable batteries. The condition of low
batteries corresponds to the appearance of "low battery
display. To replace or recharge the batteries, see § 6.1
3.5. STORAGE
To guarantee precise measurement, after a long storage time under
extreme environmental conditions, wait for the instrument to come
back to normal operating conditions (see § 7.2).
28
the following recommendations
CAUTION
SOLAR03
and
" on the