Publicité
Installing the processor
Prerequisites
Si vous remplacez un composant, retirez le composant existant avant d'exécuter la procédure d'installation.
About this task
The following images indicate the location of the processor and provides a visual representation of the installation procedure.
Steps
1. Ensure that the release lever on the processor socket is fully extended in the open position.
2. Align the notches on the processor with the tabs on the processor socket and place the processor in the processor socket.
NOTE:
The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the processor
socket. When the processor is properly seated, all four corners are aligned at the same height. If one or more corners of
the processor are higher than the others, the processor is not seated properly.
3. When the processor is fully seated in the socket, pivot the release-lever down and place it under the tab on the processor
cover.
Next steps
1. Install the
125 W heat-sink assembly
2. Install the
side
cover.
3. Follow the procedure in
Dissipateur de chaleur du régulateur de tension
Retrait du dissipateur de chaleur du régulateur de tension
Prérequis
1. Suivez la procédure décrite dans la section
AVERTISSEMENT :
Laissez-le refroidir avant de le manipuler.
or
65 W heat-sink
after working inside your
Avant d'intervenir à l'intérieur de votre
Le dissipateur de chaleur se met à chauffer au cours d'un fonctionnement normal.
assembly.
computer.
ordinateur.
Retrait et installation de composants
59
Publicité
