Publicité
Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive connector.
2. Insert the solid-state drive at a 45-degree angle into the slot on the system board.
NOTE:
When replacing a M.2 2230 solid-state drive with a M.2 2280 solid-state drive, ensure to move the standoff nut
to the M.2 2280 solid-state drive slot position.
3. Replace the screw (M2x3.5) to secure the M.2 2280 solid-state drive to the system board.
NOTE:
Repeat the above procedure for installing the other solid-state drive.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Removing the M.2 2230 PCIe solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
About this task
The following images indicate the location of the solid-state drive (Slot 2) and provide a visual representation of the removal
procedure.
26
Retrait et installation de composants
after working inside your
before working inside your
computer.
computer.
Publicité
