Publicité
8
MODAMP MODULE 1005
MODAMP MODULE 1005 Controls
(1)
(2)
(4)
(6)
(7)
(10)
(11)
(3)
(5)
(9)
(12)
(8)
(13)
(14) (15) (16)
Controls
(EN)
(1) AMPLIFIER GAIN – This knob controls the
VCA's gain and final output volume at the
OUT jack.
(2) UNMOD GAIN – This knob controls the IN A
signal gain when the module is in UNMOD
mode (as indicated by the UNMOD button).
UNMOD mode allows the module to be used as
a VCA when modulation is not required.
(3) AMPLIFIER CONTROL MODE (EXP'L/LINEAR)
– This sliding switch determines whether the
VCA gain response is exponential (EXP'L) or
linear (LINEAR).
(4) UNMOD – Press this button to place the
module into UNMOD mode. In UNMOD
mode, the IN A signal passes to the OUT jack
without any modulation, and the signal level
is controlled by both the UNMOD GAIN and
AMPLIFIER GAIN knobs. IN B does not function
in UNMOD mode.
(5) MOD – Press the button to activate MOD mode.
In MOD mode, the circuit combines the IN A
signal and the IN B signal to produce an output
signal that is a modulated combination of the
two input signals.
(6) RATIO – Use this knob in MOD mode
to offset the tune control voltage
that is sent out through the CV B jack.
This function only operates when MOD mode
is selected.
(7) TUNE – Use this knob in MOD mode to control
the output level of the tune control voltage
sent out through both the CV A and CV B
jacks. This function only operates when MOD
mode is selected.
Quick Start Guide
(8) IN A – This knob controls the input level for the
signal coming in through the IN A jack.
(9) IN B – This knob controls the input level for the
signal coming in through the IN B jack.
(10) IN A / IN B – Use these input jacks to route
in audio signals for the internal modulation
process via cables with 3.5 mm connectors.
CV A / CV B – Use these jacks to route TUNE
(11)
(CV A and CV B) and RATIO (CV B offset) control
voltages out to the two VCOs that typically
supply the audio signals to the IN A and IN B
inputs to be modulated.
(12) CV IN – Use this jack to route in control voltage
signals for remote control of the AMPLIFIER
GAIN setting.
MOD – Use this jack to route in a trigger signal
(13)
to remotely activate MOD mode via a cable
with 3.5 mm connectors.
(14) GATE – Use this input jack to route in a gate
signal to turn the modulation circuit on and off
via a cable with 3.5 mm connectors.
(15) UNMOD – Use this jack to route in a trigger
signal to remotely switch off MOD mode via a
cable with 3.5 mm connectors.
(16) OUT – This jack sends out the final VCA signal
via cable with 3.5 mm connectors.
9
Publicité
