Power Fist 9175399 Manuel D'utilisation page 9

V4.0
If improper rotation direction is detrimental to the load, check the rotation or
'bump' the motor prior to coupling the load to the motor shaft. When the motor
is coupled to the load and started, it should start quickly and run smoothly. If
not, stop the motor immediately and determine the cause. Possible causes are
low voltage at the motor, motor connections are not correct or the load is too
heavy. Check the motor current after a few minutes of operation and compare
the measured current with the nameplate rating.
CARE & MAINTENANCE
1. Maintain the device with care. A device in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the device components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Maintain the device's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
WARNING! Only qualified service personnel should repair the device. An
improperly repaired device may present a hazard to the user and/or others.
LUBRICATION
The bearings are permanently lubricated and do not require additional grease.
DISPOSAL
Recycle a device damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the device does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the device.
Visit www.princessauto.com for more information
1/4 HP Furnace Electric Motor 9175399
9