Power Fist 9175399 Manuel D'utilisation page 8

9175399 1/4 HP Furnace Electric Motor V4.0
ELECTRICAL INSTALLATION
GROUNDING THE MOTOR
Ground the motor according to CE and local codes. Consult the Canadian
Electrical Code (CE) for information on grounding of motors and generators and
general information on grounding. In making the ground connection, the
installer should make certain that there is a solid and permanent metallic
connection between the ground point, the motor or generator terminal housing
and the motor or generator frame.
WIRING YOUR MOTOR
WARNING! Do not touch electrical connections unless you first ensure that
power has been disconnected. Please refer to: OSHA standard 1910.147
titled: The Control of Hazardous energy (lockout/tag-out).
WARNING! Surface temperatures of motor enclosures may reach
temperatures that can cause discomfort or injury to personnel coming in
contact with hot surfaces. Protection should be provided by the user to
protect against accidental contact with hot surfaces. Failure to observe this
precaution could result in bodily injury.
Connect the motor as shown in the connection diagram on the motor
nameplate. Be sure to identify the proper wiring diagram for the motor you are
installing. If you have difficulty determining the proper wiring diagram for your
motor, please contact Princess Auto for assistance.
If this motor is installed as part of a motor
control drive system, connect and protect
the motor according to the control
manufacturer's diagram. When using AC
motors with frequency inverters, be certain
that the motors maximum speed rating is
not exceeded. The wiring, fusing and
grounding must comply with the Canadian
Electrical Code (CE) or International
Electrotechnical Commission (IEC) and
Fig. 1
local codes.
8 For technical questions call 1-800-665-8685