Bosch MUMS6ZS34 Manuel D'utilisation page 48

en Troubleshooting
Fault
"ALLOW APPLIANCE
TO COOL DOWN" ap-
pears on the display.
"SCALE RESET" ap-
pears on the display.
"MAX. WEIGHT
REACHED" appears
on the display.
"MIN. WEIGHT
REACHED" appears
on the display.
48
Cause and troubleshooting
Motor is overheated.
Set the rotary switch to
1.
If you are processing a large quantity of ingredi-
2.
ents, reduce the quantity to prevent overheating.
If a tool or accessory is blocked, remove the block-
3.
age.
Allow the appliance to cool down to deactivate the
4.
overload protection device.
Calibration of scales has failed.
Set up the appliance on a flat, clean work surface
1.
free of vibrations.
Check there are no objects under the appliance.
2.
Press to start calibration again, taking care not to
3.
touch the appliance during calibration.
Quantity of ingredients above measuring range of
scales.
When using the scales, observe the maximum
1.
weight of 5000 g or 11.00 lb.
Reduce the total weight to be weighed.
2.
Quantity of ingredients outside measuring range of
scales.
When using the scales, observe the minimum
1.
weight of 5 g or 0.01 lb.
Increase the total weight to be weighed.
2.
Appliance is not set up correctly.
Set up the appliance on a flat, clean work surface
1.
free of vibrations.
Check there are no objects under the appliance.
2.
⁠ .