Publicité
Les langues disponibles
Les langues disponibles
Starting Cleaning
Press the
button to start cleaning. The
robot will plan its cleaning route according
to its scan of the room. It splits a room into
zones, first draws out zone edges, and then
fills the zone in a zigzag pattern. In so
doing, the robot cleans all zones one by
one, efficiently cleaning the house.
Zone 1 – Cleaned
Zone 2 – Cleaned
Zone 4 – Next Zone
Zone 3 – In Progress
Notes:
• To allow the robot to automatically vacuum and return to
the dock, start the robot from the dock. Do not move the
dock during cleaning.
• Cleaning cannot start if the battery level is too low. Allow the
robot to charge before starting the cleanup.
• If cleaning is completed in less than 10 minutes, the area
will be cleaned twice.
• If the battery runs low during the cleaning cycle, the robot
will automatically return to the dock. After charging, the
robot will resume where it left off.
• When the VibraRise mop cloth mount is attached, the robot
will retract it when cleaning the carpet. You can also set the
carpet as a no-go zone in the app to avoid it.
• Before starting each mopping task, make sure that the
VibraRise mop has been properly installed.
Spot Cleaning
Press the
button to start spot cleaning.
Cleaning range: The robot cleans a
1.5 m (5 ft) x 1.5 m (5 ft) square area
centered on itself.
Note: After spot cleaning, the robot will automatically return
to the starting point and enter Standby mode.
Emptying
Auto-emptying will begin when the robot
returns to the dock after cleaning. Press the
Dock button to trigger emptying manually.
Press any button to stop emptying.
Note: Avoid frequent manual emptying.
Pause
When the robot is running, press any
button to pause it, press the
resume cleaning, and press the
send it back to the dock.
Note: Placing a paused robot on the dock manually will end
the current cleanup.
Refilling the Water Tank or
Cleaning the VibraRise Mop
Cloth
To add water or clean the VibraRise mop
cloth, press any button to stop the robot
and remove the mopping module. After
adding water or cleaning the VibraRise mop
cloth, reinstall the mopping module and
press the
button to continue.
09
Sleep
If the robot is paused for over 10 minutes, it
will go to sleep, and the power indicator will
flash every few seconds. Press any button
to wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left in sleep
mode for more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period
is from 22:00 to 08:00. You can use the
app to disable the DND mode or modify
the DND period. When DND mode is
activated, the robot will not automatically
resume cleanup, the power indicator
light will dim, and the volume of the
voice prompts will lower.
button to
button to
Child Lock
Press and hold the
disable the child lock. You can also set it in
the app. Once enabled, the robot will not
react to button presses when it is
stationary. When the robot is cleaning or
docking, press any button to stop it.
Charging
After cleaning, the robot will automatically
return to the dock to charge.
In Pause mode, press the
button to enable/
button to send
Publicité
