Publicité
Page 4 of 13
AERO STYLE CRASH PROTECTOR ORIENTATION
PICTURE 1
FITTING INSTRUCTIONS
Near side (left side as you sit on the motorcycle)
•
Place one of the M10 plane washers (item 3) onto one of the M10 hex bolts
(item 2) followed by one of the shake proof washers (item 4) as shown in the
left-hand side assembly picture.
•
Place the bolt with washers into one of the crash protectors (item 5), then place
one of the spacers (item 6) over the exposed end of the bolt as shown in the
left-hand side assembly picture.
•
Offer this assembly into position as arrowed in picture 1 (please ensure no parts
come in contact with any fairing panels). Finally tighten the crash protector bolt
until you feel some compression from inside the protector using 17mm socket
and wrench. PLEASE NOTE THE CRASH PROTECTOR MUST BE POSITIONED
AS IN PICTURE 'C' ON PAGE 4 WITH THE BIGGER END TOWARD FRONT
OF BIKE. Turn a little more so that you feel the compression increase slightly.
Then apply a quarter turn. Tighten to 40Nm of torque (do not exceed this
figure, as damage can occur to the motorcycle and the bolt).
•
Fit the crash protector caps (item 1) as shown in picture B.
•
Before riding please check both crash protectors are secure and will not rotate.
•
Please check tightness of crash protectors regularly.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301 www.rg-racing.com Email: info@rg-racing.com
PICTURE C
R&G
CP0493
PICTURE 2
Publicité
