Publicité
Les langues disponibles
Les langues disponibles
Instructions Secure Ethernet Adapter (43-9607B) / Secure Door Adapter (43-9606)
GB
Door Secure Adapter
Behnke surface-mounted housing series 20 /
40 / 50
Mounting material supplied:
▸
1 x bracket for sabotage contact incl.
2 stud bolts inside/outside M 2.5 x 18 mm
▸
2 x Phillips screw M 2.5 x 6 mm V2A
▸
Sabotage contact
When mounted in series 50 surface-mounted
housing:
▸
2 x spacer bolts M 2.5 x 5 mm inside/outside
▸
2 x Phillips screws M 2.5 x 4 mm
1. First detach the module housing base
without hole and spacer from the electronics
box.
2. Screw on the module housing base with hole
and spacer and screw it to the intercom base
housing.
3. Screw the sabotage contact to the 18 mm
spacer using the M 2.5 x 6 mm Phillips
*
screws.
4. Now please carry out the function test of
the sabotage contact using a multimeter.
When the sabotage contact is actuated by
inserting it into the surface-mounted hous-
ing, the switching contact is closed. Do not
connect the sabotage contact to the Door
Secure Adapter. When the button is closed,
a resistance value of approx. 5.1 kΩ should
now be measured at the terminals. Wire the
sabotage contact to the Door Secure Adapter
in the housing after performing a test mea-
surement.
*Screw spacer bolts M 2.5 x 5 mm inside / outside onto the
spacers. Screw on the sabotage contact using a Phillips screw
M 2.5 x 4 mm. Please note: Connection terminals point in the
direction of the cover of the basic electronics.
38
Top
180°
Sabotage contact mounted
Turn sabotage contact 180° when mounting
series 50 surface-mounted housing (connec-
tion terminals point to the basic electronics)
Module housing base with preparation
for sabotage contact
www.behnke-online.com
Publicité
