DHC BT2400 Manuel De L'utilisateur page 10

with the "Cable Diagnosis" tool. If the problem persists or clamp/cable need
replacing, ask your dealer for replacement parts or further diagnostics.
12V AND 24V SYSTEM TEST
1. Select "SYSTEM TEST" from the main
menu.
2. Enter the VIN of the vehicle. (same
input method as 6V/12V/24V Battery
Test)
3. Turn off loads and start engine.
4. Use directional keys to review
cranking test result.
5. Select "NEXT" to proceed to charging
test.
6. "Is it a diesel engine?"
If YES, the tester will ask the user
to rev the engine for 40 seconds
before proceeding to idle & load
on test.
If NO, the tester will proceed with
the idle and load on test directly.
7. Select "NEXT" when idle test is
completed and move on to the ripple &
load on test.
8. Turn on loads and rev engine for 15
seconds.
(The tester will countdown 15
seconds)
9. Once completed, the ripple & load test results are displayed.
10
10