Télécharger Imprimer la page

Beurer IH 28 Pro Mode D'emploi page 20

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
5. DEVICE AND ATOMISER
SET DESCRIPTION
Nebuliser
The corresponding drawings are shown on page 3.
Mains connector
1
cable
Lid
2
On/Off control
3
Compartment for
4
atomiser set
Atomiser and atomiser set
Compressed air
8
hose
Atomiser
9
Atomiser insert
10
Valve
11
Medication container
12
Mouthpiece
13
Nasal douche
Cover
20
Collection container
21
for nasal secretion
6. INITIAL USE
Setting up the device
Take the device out of the packaging.
Place the device on a flat surface.
Make sure that the vents are free from obstruc-
tions. Open the lid
2
atomiser set.
Before using the device for the first
time
Notice
• Clean and disinfect the atomiser and atomiser
set before using them for the first time. See
"Cleaning and maintenance" in this regard.
• Connect the compressed air hose
bottom of the medication container
Filter cap with filter
5
Hose connection
6
Holder for atomiser
7
Silicone adult mask
14
Silicone children's
15
mask
Nosepiece with
16
comfort attachment
Replacement filter
17
Angled fitting
18
Nasal douche
19
Saline container
22
Cover hole
23
to access the parts of the
to the
8
.
12
A 1
• Connect the other end of the compressed air
hose
to the nebuliser hose connection
8
turning it slightly.
• Insert the medication container
holder for the atomiser
Mains adapter connector
The device must only be connected to the mains
voltage that is specified on the type plate.
• Insert the mains plug of the mains cable
a suitable socket.
• To connect to the mains, fully insert the plug
into the socket.
Notice
• Ensure that there is a mains socket close to the
set-up area.
• Arrange the mains cable so that no-one will trip
over it.
• To disconnect the nebuliser from the mains
after inhalation, first switch off the device and
then pull the mains plug out of the socket.
7. USAGE
Important
• For hygiene reasons, it is essential to clean the
atomiser
and the rest of the atomiser set
9
after each treatment and to disinfect them after
the last treatment of the day.
• The atomiser set parts may only be used by
one person; use by several people is not rec-
ommended.
• If the therapy involves inhaling several differ-
ent medications one after the other, please be
aware that the atomiser
der warm tap water following every usage. See
"Cleaning and maintenance" in this regard.
• Please observe the notes on changing the filter
in these instructions for use.
• Check that the hose connectors are firmly at-
tached to the nebuliser
before each use of the device.
• Before use, check that the device is function-
ing correctly. To do this, briefly switch on the
nebuliser (together with the connected atom-
iser, but without medication). If air comes out
of the atomiser
20
A 2
12
7
must be rinsed un-
9
and the atomiser
6
, the device is working.
9
by
6
into the
into
1
9

Publicité

loading