Bergstrom INTEGRAL POWER II Instructions De Montage page 25

INTEGRAL POWER II
Secure the attachment supports by turning
13
the nuts to tighten the exterior EPDM seal
(Point 4) of the unit between 3 mm and 6 mm;
the seal should have a thickness of between
19 and 22 mm.
Important: To prevent water infiltration into the
cabin ensure the tightness of the EPDM seal
with the base of the equipment as is shown in
the diagram.
3-6mm.
Cabin roof
Turn the nuts until the
rubber seal is tight
13
between 3 and 6 mm.
Tighten (4) M8 nuts to the bracket and (4) to
14
the base of the equipment.
EPDM seal
10 mm*
(*) (approx. after tightening)
13
13
12
25
EN
Check the
compression of the
EPDM seal using
a flexometer in the
four corners.
13
14