Bergstrom INTEGRAL POWER II Instructions De Montage page 18

INTEGRAL POWER II
EN
Read this document carefully before
installing the product. Keep this document for
future reference. The original documentation
was written in Spanish, all other languages are
translations.
All product manuals are available in their digital
versions (PDF) at
https://www.bergstromspain.com/
All sales and warranty transactions are subject
to our general conditions of sale in their latest
version, published on our website
https://www.bergstromspain.com/
Explanation of symbols
- Warning: A safety warning indicating a
!
situation which, if not avoided, could result in
death or serious injury.
- Danger: Cutting risk. Indicates a situation that
could lead to cutting.
- Danger: Risk of electrocution. Indicates a
situation that could lead to electrocution.
- Caution: Safety warning informing about a
situation, which if not avoided, could result in
damage to the unit or other materials.
- Information: Additional information on the
installation or handling of the product.
- Fragile: Indicates a situation in which care
must be taken to avoid damage to the unit and
other materials.
Explanation of liability
- Dirna Bergstrom accepts no responsibility for
damage caused in the following cases:
• Damage to the product due to mechanical
influences and surges.
• Modifications made to the unit without the
manufacturer's express consent.
• Use of the unit for purposes not described
in this document.
• Improper handling or installation of the unit.
- It is forbidden to tamper with the refrigerant
gas circuits without the manufacturer's express
authorisation.
Warnings during assembly
!
- The installation, repair and maintenance of this
air conditioning unit may only be carried out by
technical staff with sufficient training in vehicle
air conditioning, possible dangers and applicable
standards.
- Attention! Weight of the unit 52 kg.
- Read the installation instructions carefully before
starting to install the unit. During installation,
follow the instructions carefully.
- When installing air conditioning equipment on
roof, the upper cabin part must be protected with
a cloth or a protective blanket to avoid possible
scratches. When installing INTEGRAL POWER
on roof, take into account that, normally, cabins
equipped with a hatch have a strong enough
structure to hold equipment weight. However,
if it is not the case and it is necessary to carry
out a cut in the roof or, although it has a hatch,
the material is not resistant enough (if roof is
made of fibre, plastic, etc...), it is the installer
who will have to decide, under his responsibility,
if it is necessary to reinforce the roof to avoid
possible deformations, breaks, water entries, etc.,
habilitating the means required to stop it from
occurring.
- With plastic roof cabins, take special care and
only rest on cabin nerves to avoid fibre part from
sinking.
- Switch off the ignition key before starting to install
the unit.
- Disconnect the vehicle's battery before starting to
install the unit.
- Install INTEGRAL POWER securely to prevent it
from falling.
- Use the appropriate tools for each operation.
- During installation, ensure the connection of the
electrical components, checking that they are
fitted correctly.
- If during installation of the unit the cables pass
through walls with sharp edges, use conduits or
guides to prevent damage to the cables.
- If during installation the unit is tilted, or the cab
is tilted with the unit installed on top, you must
wait at least 60 minutes after placing the unit in
horizontal position before it is started.
- Unit pre-charged with r-134a refrigerant gas.
18