Bergstrom INTEGRAL POWER II Instructions De Montage page 23

INTEGRAL POWER II
Position (2) fastening supports with (4)
7
washer and (4) M8 self-locking nut, without
fully tightening.
7
Thread 10 mm (4) M6 x 55 or 80 studs as
8
indicated, in accordance with the distance (D)
of the diagram in point 11.
Position (1) Ø6 rubber washer, (1) Ø6 flat
9
wide-rimmed washer and (1) M6 nut on each
of the M6 studs. Tighten the nut until the
rubber washer compresses slightly.
7
7
8
*
9
23
EN
*
Rubber
washer
Wide-rimmed
washer
M6 Nut