Gaggenau RC282305 Notice D'utilisation page 36

Faults – what to do?
en
Faults – what to do?
3
B efore you call customer service, use this table to check whether you can rectify the fault yourself.
F a u l t s – w h a t t o d o ?
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display shows E....
Electronics have detected a fault.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
It is too warm or too cold in the cool-fresh compartment.
The standard setting has been set too high or low (e.g. frost
in the cool-fresh compartment).
--------
36
Switch off appliance for 5 minutes.
"Switching off and disconnecting the appliance"
~
on page 29
If the temperature is too warm, check temperature again after
a couple of hours.
If the temperature is too cold, check temperature again on the
following day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call Customer Service.
"Customer service" on page 37
~
Start the appliance self-test.
"Appliance self-test" on page 37
~
When the programme has ended, the appliance switches
over to normal operation.
You can set the temperature in the cool-fresh compartment to
be 3 settings warmer or colder. If the temperature in the
refrigerator compartment is set to setting 0, the cool-fresh
compartment has a temperature of around 0 °C.
1 Press and hold the refrigerator compartment Û button
until the display temperature refrigerator compartment
flashes.
2 Press –/+ button to change the setting.
Setting –3 corresponds to the coldest setting.
Setting +3 corresponds to the warmest setting.
The selected setting is saved after one minute.