Installation and connection
5
S cope of supply
I n s t a l l a t i o n a n d c o n n e c t i o n
After unpacking all parts, check for any damage in
transit.
If you have any complaints, contact the dealer from
whom you purchased the appliance or our customer
service.
"Customer service" on page 37
~
The delivery consists of the following parts:
▯
Built-in appliance
▯
Interior fittings (depending on model)
▯
Installation material
▯
User manual
▯
Installation instructions
▯
Customer service booklet
▯
Warranty enclosure
▯
Information on the energy consumption and noises
Technical specifications
Refrigerant, cubic capacity and further technical
specifications can be found on the rating plate.
"Getting to know your appliance" on page 26
~
Installation and connection
Installing the appliance
Installation location
The more refrigerant an appliance contains, the larger
the room must be in which the appliance is situated. In
rooms which are too small leaking refrigerant can form a
flammable gas-air mixture.
Per 8 g of refrigerant the room must be at least 1 m³ in
size. The amount of refrigerant in your appliance is
indicated on the rating plate inside the appliance.
"Getting to know your appliance" on page 26
~
The weight of the appliance may be up to 69 kg
depending on the model.
Permitted room temperature
The permitted room temperature depends on the
climatic class of the appliance.
Information on the climatic class can be found on the
rating plate.
"Getting to know your appliance" on page 26
~
Climatic category Permitted room temperature
SN
+10 °C ... 32 °C
N
+16 °C ... 32 °C
ST
+16 °C ... 38 °C
T
+16 °C ... 43 °C
The appliance is fully functional within the permitted
room temperature.
If an appliance of climatic class SN is operated at
colder room temperatures, the appliance will not be
damaged up to a room temperature of +5 °C.
Cavity dimensions
Cavity depth
A cavity depth of 56 cm is recommended
for the appliance. If the cavity depth is smaller – at least
55 cm – the energy consumption increases slightly.
Cavity width
An inside cavity width of at least 56 cm is required for
the appliance. If this is not the case, problems may
occur when installing the appliance.
en
23