FILL-RITE NX25-DDC Serie Manuel D'installation Et D'utilisation page 7

|
DC Power Connection
DANGER
Be certain the switch is "OFF" prior to connecting the power cables to the power source or installing the cable into the pump to prevent
unexpected starting of the motor. Unexpected motor start can cause unintended discharge of fuel, creating an explosion and fire hazard. Note
that the switch does not interupt power to the motor; it triggers a relay that tells the motor to turn on.
WARNING
BE CERTAIN the power cables are connected to the correct terminals at your power source. REVERSING POLARITY WILL DAMAGE THE PUMP
and void the warranty.
CAUTION
Do not remove the fuse on the red (positive) wire.
Removing the fuse MAY DAMAGE THE PUMP and
will void the warranty.
Inspect power cable before each use! Damage to the outer jacket of the cable
that exposes wiring requires replacement of the power cable.
1. The green (ground) wire should be connected first. Connect the green wire
to the vehicle chassis or earth ground. DO NOT connect the green wire to
the negative power source post.
2. Next, connect the black (negative) wire to the negative post of the DC
power source.
3. Connect the red (positive) wire to the positive post last.
Install power cable by aligning flat on plug with back of pump. Insert the plug
into the motor housing as shown. Lock into place using the threaded collar (A).
HAND TIGHTEN ONLY!
Disconnect in reverse order.
Padlocking
Your Fill-Rite pump nozzle can be padlocked to the pump for added security.
With the pump turned off, and the nozzle in the stored position, a padlock
can be inserted through the locking link and the nozzle handle opening. This
configuration prevents the nozzle from being removed from the nozzle boot.
The locking link is located on the nozzle side of the pump, and can be pivoted
into position to work with a variety of nozzles.
Use the appropriate position and hole to lock your nozzle securely to your
NX25-DDC pump.
fillrite.com
NX25-DDC SERIES DC FUEL TRANSFER PUMPS
INSTALLATION AND OPERATION MANUAL
Flat
A
Green
1
Earth /
Chassis
Ground
Black Red
2 3
Locking Link
7