Blackmagic Design Blackmagic 2110 IP Manuel D'installation Et D'utilisation page 22

Ancillary Data Identifier
Blackmagic 2110 IP Converters support SMPTE-2110-40 ancillary data elementary streams. This
data can include closed captions, tally, timecode and metadata. The ancillary data identifier
table indicates the type of ancillary data that is present once added.
The ancillary information will be identified by a data identifier or DID and secondary data
identifier, or SDID. The converter includes common timecode and caption data, but you can add
up to three additional identifiers.
To add an additional ancillary data identifier to the list:
1 Click on the plus sign button to add a new row.
2 Enter a name for the data. This name will be visible when routing SMPTE streams using an
NMOS controller.
3 To disable any ancillary data, uncheck the corresponding box in the far right column.
Multicast Address
Each ST 2110 stream output from your Blackmagic 2110 IP Converter 3x3G uses a discrete
multicast address that can be found via the LCD menu. If you are using Blackmagic
Converters Setup you can view and modify the discrete address and port number for each
elementary stream.
To change the multicast output address:
1 Select the output using the 'sending from' menu.
2 Tick the checkbox for auto or manual IP configuration.
3 Enter a new IP address and port number into the fields and click the save button at the
lower right of the utility.
Installing into a Blackmagic Universal Rack Shelf
Your Blackmagic 2110 IP Converter 3x3G shares a compatible form factor with many other
Blackmagic Design units that can be mounted in a rack. The next section of this manual shows
how to install the converter into the Blackmagic Universal Rack Shelf.
Blackmagic Converters Setup 22