Blackmagic Design Blackmagic 2110 IP Manuel D'installation Et D'utilisation page 20

2110
The 2110 tab provides settings for routing SMPTE 2110 streams along with settings for PTP,
multicast address and identifying ancilliary data.
2110 Receiver and Sender Settings
You can route incoming sources to the 2110 IP converter using the receiver settings in the
Converter Setup utility.
To route an incoming source:
1 Click on the magnifying glass to the right of the receiver field. A window will appear
listing all available 2110 IP streams on the network listing both the IP node details and
source label.
2 Select an available stream from the list and click the 'select' button. The window will close
and return to the 2110 tab of the setup utility. You should now see the incoming source on
the front panel LCD display on the converter.
Blackmagic Converters Setup 20