Sony SU-LW1 Mode D'emploi page 18

3
2
4
18
(US)
1
3
6
Mount the display on the Plate
Unit.
1To lock the arms temporarily, put the two
securing screws (+B5 × L12, supplied) in the
holes on the arm bases B from the outside.
2Hang the upper hooks of the Mounting Hook
Units on the upper shafts of the arms.
3Place the lower hooks of the Mounting Hook
Units on the lower shafts of the arms.
Do not push
4Pushing the display towards the Plate Unit,
the screws in
lift it up slowly and hang the lower hooks of
too far.
the arms onto the lower shafts.
5Check to make sure that all eight hooks are
properly hung on the corresponding shafts.
6Tighten the securing screws attached in 1.
Note
If you push the securing screws into the holes
too far (1), the tips of the screws will get in the
way when you hang the lower hooks on the
shafts (4).