Dynamic Alignment: Swing Resistance
Flexion Resistance:
a) Initial adjustments are factory set (Extension 2, Flexion 4)
b) Observe the amputee walking
c) If there is excessive heel rise: Increase resistance
3
Extension Resistance:
a) Observe the amputee
walking
b) If there is excessive
terminal impact on knee
extension:
Increase resistance
c) If the knee does not extend
satisfactorily:
Decrease resistance
NB: As a 'rule of thumb'
exceed extension resistance
4
N.B. If there is any doubt over the position of the indicator ring in relation to the settings, its position can be reset by turning
Stirrup function and features
How to switch off stance
resistance (for cycling etc)
1) Load toe of prosthesis
2) Lift lever (stirrup)
3) Stance now off and knee will
4) Lower stirrup to resume normal
be unstable
operation
right MIN to 10.
counterclockwise until
the MIN is over the
is at minimum.
By turning the cap
clockwise the resistance
is increased to a
maximum setting at 10.
cap. By turning the adjustment cap in the clockwise direction until it
reaches maximum and then continuing, the indicator mark will begin
moving from right to left.
The indicator mark will move
clockwise from 1 to 10 on the
extension marker which is located
directly below the indicator mark.
then be readjusted to the desired
N.B, to reduce extension resistance turn the adjuster cap to minimum
and continue turning until the desired extension resistance is reached.
(for prolonged standing etc)
1) Flex knee slightly without overriding
stance resistance
2) Lift stirrup
but will extend
4) Lower stirrup to resume
normal operation
4
8
M I N
M A X
9
1
X
8
2
10
7
3
6
4
5
indicator mark
minimum
maximum
M A X
9
M I N
10
1
10
10
1
9
9
2
8
8
3
7
6
4
5
indicator mark
maximum
minimum
extension
extension
938216/12-0819
1
2
3
7
4
6
5