Parkside PKS 1500 B3 Consignes D'utilisation Et De Sécurité page 8

2. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment and suc-
cess.
Note:
In accordance with the applicable product liability laws, the
manufacturer of this device assumes no liability for damage
to the device or caused by the device arising from:
• Improper handling,
• Failure to comply with the operating instructions.
• Repairs carried out by third parties, unauthorised special-
ists.
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failure of the electrical system in the event of the electri-
cal regulations and VDE provisions 0100, DIN 57113 /
VDE0113 not being observed.
Please consider:
Read through the complete text in the operating manual be-
fore installing and commissioning the device.
The operating manual is intended to help the user to become
familiar with the machine and take advantage of its applica-
tion possibilities in accordance with the recommendations.
The operating manual includes important instructions for safe,
proper and economic operation of the device, for avoiding
danger, for minimising repair costs and downtimes, and for
increasing the reliability and extending the service life of the
device.
In addition to the safety instructions in this operating manual,
you must also observe the regulations applicable to the op-
eration of the device in your country.
Keep the operating manual package with the machine at all
times and store it in a plastic cover to protect it from dirt and
moisture. They must be read and carefully observed by all
operating personnel before starting the work.
The device may only be used by personnel who have been
trained to use it and who have been instructed with respect
to the associated hazards. The required minimum age must
be observed.
In addition to the safety instructions in this operating manual
and the separate regulations of your country, the generally
recognised technical rules relating to the operation of such
machines must also be observed.
We accept no liability for accidents or damage that occur
due to a failure to observe this manual and the safety instruc-
tions.
3. Device description (fig. 1-16)
1. On/off switch
2. Locking switch
3. Handle
4. Machine head
5. Moving saw blade guard
6. Saw blade
7. Set screw for rotary table
8. Stop rail
8a. Moveable stop rail
8b. Locking screw
9. Fixed saw table
10. Table insert
11. Scale
12. Pointer
13. Rotary table
14. Set screw for workpiece support
15. Clamping device (workpiece clamp)
16. Locking screw
17. Dust bag
18. Workpiece support
19. Locking screw for clamping device
20. Locking screw for drag guide
21. Stand bracket
22. Adjusting screw (45°)
22a. Locknut adjusting screw (45°)
23. Locking screw
24. Clamping handle
25. Locking pin
26. Adjusting screw (90°)
26a. Locknut adjusting screw (90°)
27. Scale
28. Pointer
29. Flange screw
30. Outer flange
31. Guide bar
32. Sawing shaft lock
33. Laser ON/OFF switch
34. Battery cover
35. Laser
GB/IE/NI/CY/MT 3