Siemens SITRANS FUH1010 Instructions De Service page 53

Note
If you receive a Detection Fault message, it is strongly recommended that the Technical
Service Department (http://www.automation.siemens.com/partner) be contacted.
5.2 Alarm Codes
The following alarm codes appear on the main display of the flow meter.
Table 5- 2 Alarm Codes and Descriptions
Letter Codes
SPACE Spacing
EMPTY Empty
HI / LO Rate
FAULT Fault
AER Aeration
MEMRY Memory
MAKUP Makeup
I Interface
P Pig
Z ZeroMatic
The displays shown below indicate where the Alarm Codes appear on the screen. Press
<UP> or <DOWN> Arrows to change screen views.
①
FUS1010 IP65 NEMA 4X & IP66 NEMA 7 Quick Start
Operating Instructions, 01/2013, A5E03086486-AC
Alarm Code Description
Sensor spacing may need adjustment
Pipe is empty
Flow above High setting or below Low setting
Three continuous seconds without new data update
Current aeration percentage exceeds the alarm set point
Last valid reading for a selected interval during Fault condition
In-Process Makeup occurred
The following alarm codes appear in the Datalogger status messages:
Liquid Vs exceeds interface alarm set point
Pig passage detected (optional)
ZeroMatic signal occurred
14.35
354.6597
14.27
Alarm Codes
100.0
0.0
31.74
Troubleshooting
5.2 Alarm Codes
51