F4
8 - DIP SWITCH DIP1
The settings are stored during the rest phase (gate closed
The default settings are highlighted in the boxes with grey background .
DIP
Function
PHOTOCELL
DIP1_1
DURING
OPENING
OPERATING
DIP 2
1_
LOGIC
(SEE PAUSE TRIMMER)
DIP 3
1_
ELECTRIC LOCK
RELEASE STROKE
Status
Description
When the photocell is broken/interrupted during both opening and closing, the gate
motion is ceased until the photocell is re-made.
Subsequently the gate will always OPEN.
ON
Breaking or interrupting the photocell during PAUSE will cause the pause-time
to begin counting down again.
The photocell stops and immediately inverts the gate motion during closing
while it is uninfluential during opening.
OFF
Breaking or interrupting the photocell during PAUSE will cause the pause-time
to begin counting down again.
AUTOMATIC logic
Operation in response to the START command:
• Gate closed
• During opening
• Gate open
ON
• During closing
STEP-BY-STEP WITH STOP logic
Operation in response to the START command:
• Gate closed
• During opening
OFF
• Gate open (PAUSE)
• During closing
• After a STOP
Operation: following a START, OPENING or PEDESTRIAN command, the
following will occur in sequence:
• electric lock activation
• closing pulse of 1 second
• opening
• after 2 seconds, electric lock deactivation
ON
Operation AT THE END OF CLOSING CYCLE (ONLY WITH SLOW-DOWN
ENABLED):
• extra movement in closing of 1 second with FORCE trimmer settings.
This function cannot be activated with a sliding gate configuration and is
unadvisable with electromechanical operators.
Electric lock release stroke disabled.
OFF
Simultaneous electric lock activation and opening.
).
OPENS
UNINFLUENTIAL
If automatic closing is enabled (see PAUSE trimmer
function) then the pause-time begins again, otherwise it
closes. If automatic closing is enabled (as above) then a
permanent START command (always closed) will hold
the gate open, otherwise it closes.
OPENS
OPENS
STOPS
If automatic closing is enabled then the gate stops
STOPS
Inverts the motion
17
UK