SolaX Power T-BAT-H 5.8 Manuel D'installation page 100

Wiring between inverter and BMS
• Power cable
BMS to inverter:
• "BAT+" on the BMS to "BAT+" on the inverter;
• "BAT-" on the BMS to "BAT-" on the inverter;
T-BAT H 5.8
T-BAT H 5.8 V2
4
*Note:
1. The user must make sure that the electricity is turned off before wiring the BMS into the
inverter;
2. A positive click will be felt when correctly inserting the power cable into the
corresponding positive (BAT+)/negative (BAT-) ports on the inverter;
3. Check to make sure that the two power cables are held securely into the inverter;
4. Don't violently remove the cables when they are locked.
94
*Note: For the other
end of the power cable
connecting to the
inverter, please refer to
the Installation Manual
of inverter.