Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE BATTERIES
WARNING !
Use extreme caution when working with batteries. Sulfuric acid in batteries can cause severe injury if allowed to contact the skin or
eyes. Explosive hydrogen gas is vented from the batteries through openings in the battery caps. This gas can be ignited by any
electrical arc, spark or flame.
When Servicing Batteries...
*
Remove all jewelry
*
Do not smoke
*
Wear safety glasses, rubber gloves and a rubber apron
*
Work in a well-ventilated area
*
Do not allow tools to touch more than one battery terminal at a time
CAUTION !
Electrical components in this machine can be severely damaged if the batteries are not installed and connected properly. Batteries
should be installed by Nilfisk-Advance, a qualified electrician, or the battery manufacturer.
1
Remove the batteries from their shipping crate and carefully inspect them for cracks or other damage. If damage is evident, contact the carrier that delivered
them or the battery manufacturer to file a damage claim.
2
Turn the Master Key Switch (20) OFF and remove the key.
3
Tip the recovery tank to the side, locked position. Remove the battery cables from inside the battery compartment.
4
Carefully lift the batteries into the battery compartment and arrange them exactly as shown. Secure the batteries as close to the back of the machine as
possible.
5
The terminals on the battery cables are marked "+" for positive and "–" for negative. Install the battery cables as shown, with the terminals marked "+"
on the positive battery terminals and the terminals marked "–" on the negative terminals. Position the cables so the battery caps can be easily removed
for battery service.
6
Carefully tighten the nut in each battery terminal until the terminal will not turn on the battery post. Then tighten the nut one additional turn. Do not over-
tighten the terminals, or they will be very difficult to remove for future service.
7
Coat the terminals and posts with spray-on battery terminal coating (available at most auto parts stores).
8
Put one of the black rubber boots over each of the terminals.
34 - FORM NO. 56041516 - ConvertaMAX
24V
™
28/34, I-MAX
36V
™
28HD/34HD, BA 750/850
Publicité
