Preparing To Connect The Water; Attaching The Edge Protection; Side-By-Side Installation - Gaggenau RB 491 Instructions D'installation


Select screws according to the thickness of the wooden
beam: length = min. 2.5 x beam thickness, diameter
#12 or #14.
Specify the number of screws according to the
cavity width, thereby ensuring that the beam can
be attached securely.
According to the subsurface:

Locate wall studs near the rear panel of the cavity and
mark drill holes in the beam
or

Fasten suitable dowel into the rear wall.

Predrill the wooden beam.

Attach the wooden beam to the rear panel of the cavity.
8.

Preparing to connect the water

(only for appliances which require a water connection)
m
CAUTION
Turn off the main water tap to prevent damage
caused by leaking water.

Attach the connecting pipe to the shut-off valve
according to the instructions supplied by the
manufacturer of the ice maker installation kit.

Install the connecting pipe.
Always observe the indicated gap dimensions to
prevent damage to the connecting pipe when pushing
in the appliance.

Attach the connecting pipe to the floor with adhesive
tape.
NOTE
m
9.

Attaching the edge protection

To protect the corners of the installation cavity, attach the
supplied protective brackets with adhesive tape.

10. Side-by-Side installation

If a side-by-side installation is intended, now connect the
two appliances together.
Detailed information on installation can be found in
the separate installation instructions for the sealing kit
for side-by-side installation.
The following work steps must be performed on two
interconnected appliances.
21