13
Drill a
/
" (10 mm) diameter hole any depth
32
exceeding the minimum embedment. Use the provided
drill.
Clean hole or continue drilling additional depth.
Manually insert the screw into the wall plug until the
screw begins to resist.
Knock the wall plug and screw into the hole until the
screw head is approx.
bracket.
Tighten the screw.
Additionally use the supplied wood screws
(if the subsurface allows).
20
1
/
" (13 mm) from the anti-tip
2
7.
Attaching an alternative anti-tip
device
IMPORTANT NOTE
If the anti-tip brackets cannot be attached securely,
an alternative anti-tip device can be attached.
However, ensure that there is no play between the
appliance and the anti-tip device.
If possible, always screw the wooden beam to
existing studs on the rear panel of the cavity.
Saw the wooden beam (cross section min. 3" x 4")
to the required length.
Length is equal to the width of the installation cavity!
– If the installation cavity is deeper than the
appliance, select a beam which has a larger cross
section or attach 2 beams.
– The beam must cover the appliance by
at least 2" (50.8 mm).
Mark the installation height (lower edge of the beam) on
the rear panel of the cavity.
NOTE