Thermador PROFESSIONAL Pro Harmony PRD305PH Manuel D'instructions page 5

5. Disconnect the igniter.
A.) Disconnecting a Two Piece Igniter
1) Carefully pull up on the burner base.
Electrode
Ignitor Housing
Ignitor Wire
B.) Disconnecting a Single Piece Igniter
1) Carefully pull up on the burner base.
2) Disconnect the female terminal on the spark wire
from the male terminal on the electrode for each
burner.
IMPORTANT: The locking tab on the female
connector must be depressed to release from the
terminal on the electrode.
Electrode
6. From each burner pedestal, remove the burner
pedestal screws with a T-30 Torx screwdriver.
Burner Pedestal Burner Pedestal Burner Pedestal
Burner Base
Burner Base
Ignitor Wire
Venturi
7. Carefully remove the burner pedestal and the venturi.
8. Remove the spill trays by rotating the trays up and out
the back.
9. Remove the heat shield, on some models. Some
models have a double-width shield that extends under
adjacent spill tray.
LP Regulator Conversion
The gas regulator is located in the cooktop, left side of
appliance. Exact location will vary per model.
1. Remove conversion
cap with a 7/8"
socket or wrench.
English 3