FALMEC Brera Mode D'emploi page 29

1
Area 1: hours
Area 2: tens of minutes
Area 3: minutes
Maximum setting time: 9 hours 59 minutes
- After 5 seconds the timer will start the countdown.
- At the end of the countdown, the relevant cooking area will be switched
off and an acoustic signal will sound.
- Press any key to deactivate the acoustic signal.
AUTOMATIC HEATING FUNCTION:
sets the maximum power for a preset time and returns to the previous
power level.
-Press the key of the cooking area to be set. The bottom right-hand dot
lights up
- Slide your finger to the right in the power level selector switch and stop at
the desired level. The functioncan only be activated for levels 1 to 8.
0 1 2 3 4 5 6 7 8 9
- Press and hold the selected level for 3 seconds
0 1 2 3 4 5 6 7 8 9
- The cooking area display indicates the activation of the function
Function duration table:
Automatic heating function time
Power level
(seconds)
1 48
2 144
3 230
4 312
5 408
6 120
7 168
8 210
9 Function not available
P Function not available
- When the time elapses, the function ends and the cooking area is reset to
the previously set power level.
To deactivate the AUTOMATIC HEATING function:
1 - Wait for the end of the function time
or
2 - Press the cooking area key for 3 seconds
- the function ends and the cooking area is reset to the previously set
power level.
or
3- If a lower power level is set than before the automatic heating function, the
function is deactivated.
2 3
3 sec
RECALL FUNCTION:
enables the recovery of cooking settings prior to an accidental cooker
top switch-off.
- Perform the following steps within 6 seconds of an accidental switch-off
- Turn on the cooker top
- The pause key flashes
- Press the pause key
The RECALL function resets the operation of the cooking areas, timer fun-
ctions and quick heating. Other functions will not be restored.
WHAT TO DO IN CASE OF COOKERS PROBLEMS
The cooker or cooking areas do not turn on:
• The cooker is not connected to the electric network.
• The protection fuse is released.
• Check if the block is not active.
• Keys are covered with water or grease.
• An object is placed on the keys.
The symbol is displayed .
• There is no saucepan on the cooking area.
• The container used is not compatible with cooktops.
• The diameter of the saucepan bottom is too small compared to the
cooking area.
The symbol [E] is displayed:
• Disconnect and connect the cooker.
• Contact the after-sales centre.
One of the area or the entire cooker turns off:
• The safety overheating system is active;
• The cooker or one cooking area remains on for too long;
• one or more keys are covered;
• one of the saucepans is empty and the bottom overheated.
The fan keeps on working after the cooker shutdown:
• This is not a malfunction: the fan keeps on protecting the electronic
power unit of the device.
• The fan stops automatically.
COOKERS ERROR CODES
In case of error, the device displays error codes for support purposes.
The display of the cooking area shows the error code alternating 'E' with
other symbols and numbers.
Error Description
code
Continuous acti-
+ vation of a key
+ 0 + 3
Internal tempera-
+
ture above 85°C
+ 2 + 1
Incorrect configu-
+
ration
+ 3 + 1
Internal supply
+
voltages too high
+ 4 + 2
or low
28
Possible Solution
causes
- Metal objects - Move the metal
above the objects
keyboard - Dry the water
- water over the
keyboard
- covered or - Allow internal heat
insufficient ven- dissipation
tilation areas
- configuration - Contact Technical
error Supportstenza
tecnica
Overcharging - Contact Technical
due to atmo- Support
spheric dischar-
ge, electrical
system failure or
incorrect power
connection