Chicco Oasys 2-3 Mode D'emploi page 32

passenger seat or any other back seats, al-
ways in a forward facing direction. Never use
this child car seat on vehicle seats which are
facing sideways or rearwards (diag. 4)
WARNING! According to car accident statis-
tics, the rear seats of a vehicle are generally
safer than the front seat: it is therefore recom-
mended to fi t the child car seat into the rear
seats of the car. In particular, the central rear
seat is the safest, when fi tted with a 3-point
safety strap: in this case it is recommended to
fi t the child car seat onto the central rear seat
of the vehicle.
If the child car seat is fi tted in the front seat
of the car, in order to ensure maximum safety,
it is recommended to push the seat back as
much as possible, bearing in mind the comfort
of the passenger sitting in the seat directly be-
hind it and adjusting the backrest to the most
vertical position. If the vehicle is fi tted with an
adjuster to regulate the height of the safety
belt, position it as low as possible. Check that
the safety belt adjuster is behind (or at the
most aligned) with the backrest of the vehicle
seat (Diag. 5A and 5B).
It is not recommended to fi t the child car seat
into a front seat equipped with airbag. If you
wish to fi t the child car seat in any seat pro-
tected by airbag, always refer to the vehicle
instructions manual.
Make sure that the buckle seat belt is not too
high and not rests on the armrest of the car
seat (Diag 3). Otherwise, try to install the car
seat for your child on another car seat in the
car.
INSTRUCTIONS FOR USE
Contents
Fitting the child car seat inside the vehicle us-
ing safety belts and placing the child inside
Installing the child seat inside the vehicle
without the child inside
How to remove the child from the child car
seat
Removal of the child car seat from the vehicle
Installing and removing the cup holder
Adjusting the height of the back rest
Adjusting the width of the back rest
Adjusting the inclination of the child car seat
backrest/seat
Removable backrest/seat covers
Cleaning and maintenance of the seat covers
Parts
A. Headrest
B. Diagonal belt guide
C. Backrest
D. Armrests
E. Seat
F. Lap belt guide
G. Cup holder
H. Reclining adjuster button
I. Safety belt guide open/close button
J. Cup holder clip
K. Backrest width adjuster wheel
L. Backrest height adjuster lever
M. Rear pocket for instruction booklet
N. Side wings
Fitting the child car seat inside the vehicle
using safety belts and placing the child in-
side
WARNING! These instructions and diagrams
are for the installation of the child car seat on
the right back seat.
To fi t the child car seat in other positions, carry
out these operations in the same order.
1. Place the child car seat onto the vehicle seat
with the backrest up against the vehicle seat
backrest (Diag. 6)
WARNING! Check that the vehicle headrest
does not interfere with the child seat headrest:
it must not push it forwards (Diag. 7). If this
happens, remove the headrest from the vehi-
cle seat where you intend to install the child
car seat. Remember to replace the vehicle
headrest when the child car seat is removed
and a passenger uses the seat.
WARNING! The rear side of the child car seat
must be resting against the vehicle seat.
2. Place your child inside the car seat with his
back correctly placed against the backrest.
3. Check the backrest height (see paragraph
32